Previous Year Very Short Questions of EIM (DIPLOMA electronics and communication engineering 3rd)

  1. Home
  2. psbte
  3. diploma
  4. ece
  5. 3rd
  6. eim
Watch More

Electronics instruments and measurement

Previous year question paper with solutions for Electronics instruments and measurement

Our website provides solved previous year question paper for Electronics instruments and measurement . Doing preparation from the previous year question paper helps you to get good marks in exams. From our EIM question paper bank, students can download solved previous year question paper. The solutions to these previous year question paper are very easy to understand.

These Questions are downloaded from www.brpaper.com You can also download previous years question papers of 10th and 12th (PSEB & CBSE), B-Tech, Diploma, BBA, BCA, MBA, MCA, M-Tech, PGDCA, B-Com, BSc-IT, MSC-IT.

Question papers (year-wise)
Very short questions
Print this page
  1. The limiting error is used to specify the ……… of an instrument.
  2. The error occurs due to the human mistake in measurement are……
  3. A PMMC instrument produces no ……... due to hysteresis.
  4. The deflecting torque is ……. to the square of the current flowing through the coil.
  5. PMMC consume ….. power
  6. Probe impedance changes with ……..
  7. A dual beam oscilloscope has …..… electron gun.
  8. Phase and time delay is measured by using ……..
  9. Electrostatic focusing system consists of ….. anode.
  10. The operating frequency range of RF heterodyne wave analyzer is from …… to ……
  11. A fine spectrum analysis with a wave analyzer shows various …… frequency.
  12. The Anderson’s bridge is ……. Complex than Maxwell bridge.
  13. The frequency can be measured by using …… bridge.
  14. The dual slope integrator type DVM is a …….. measuring device.
  15. CRO stands for________.
  16. Multimeter measures resistance, voltage and _______.
  17. PMMC stands for_______.
  18. Measurement is a process of comparison of unknown quantity with __________ quantity.
  19. ________ is the heart of CRO.
  20. In signal generator, energy is converted from ______ to A.D.
  21. An ohmmeter section of typical multimeter is used to measure ________.
  22. Direct and ________ are two types of measurement methods.
  23. There are __________ types of anode in C.R.O.
  24. Maxwell Bridge is used to measure ____________.
  25. ADC stands for _____________.
  26. The accuracy of a digital meter is ____________ than analog meter.
  27. Schmitt trigger is used for generating ________ waveform.
  28. Voltmeter is used to measure ________.
  29. The difference between the actual reading and measured value is known as _____________.
  30. The RLC meter can measure …………………....