Previous Year Very Short Questions of SOM (DIPLOMA automobile engineering 4th)

Strength of materials

Previous year question paper with solutions for Strength of materials

Our website provides solved previous year question paper for Strength of materials . Doing preparation from the previous year question paper helps you to get good marks in exams. From our SOM question paper bank, students can download solved previous year question paper. The solutions to these previous year question paper are very easy to understand.

These Questions are downloaded from www.brpaper.com You can also download previous years question papers of 10th and 12th (PSEB & CBSE), B-Tech, Diploma, BBA, BCA, MBA, MCA, M-Tech, PGDCA, B-Com, BSc-IT, MSC-IT.

Print this page
  1. The strain has …………………… units.
  2. A beam whose both ends are fixed is known as……………………
  3. The unit of moment of inertia is……………………
  4. If the strut is vertical it is known as ………………..
  5. ………………. Springs are called semi elliptical, leaf spring or carriage spring
  6. Leaf spring is used to absorb shocks and vibration. (T/F)
  7. A solid shafts are stronger than hollow shafts. (T/F)
  8. The ratio of the critical load to the safe load is known as factor of safety. (T/F)
  9. Moment of inertia is also called second moment of area.(T/F)
  10. A simply supported beam is one which is supported on more than two supports.(T/F)
  11. Pascal is the unit of…….. in ……….. system.
  12. Point of contra flexure occurs in ………..Beams
  13. Isotropic material means ……………in all directions.
  14. Moment of inertia of a section is minimum about an axis passing through………….
  15. …………Springs can carry compressive as well as tensile loads.
  16. Euler,s formula is applicable only for …………
  17. The shear force diagram for a cantilever with U.D.L. over the whole span will be…….
  18. The torque transmitted by a hollow shaft is given by ………….
  19. Stress due to suddenly applied load is ……….to that of gradually applied loads
  20. ………… are the elastic bodies which absorb energy due to resilience.
  21. The rod of a ceiling fan is subjected to __________________stress.
  22. Energy stored in a body within __________limits is known as resilience.
  23. The polar moment of area of a circular section of diameter d is ______________.
  24. Maximum bending moment occurs in a beam where the sheer force is______________.
  25. Point of contraflexure is a point where the bending moment is _______________.
  26. In case of a cantilever tensile stress are induced ______________the neutral axis.
  27. Torque produces ______________ stress in a member.
  28. The minimum load at which the column tends to buckle is called ________________.
  29. The strength of a column depends upon the ________________ and its end conditions.
  30. Close coil helical springs subjected to direct axial load, mainly develop _______________stress.