Solved question paper for SFE May-2010 (DIPLOMA 4th)

Solved Question Paper

Soil and foundation engineering May-2010

PSBTE • DIPLOMA • Cvil Engineering • 4th • May-2010

Soil and Foundation Engineering is a 4th semester subject in the Diploma in Engineering course under the Punjab State Board of Technical Education. On this page, students can look for subject-wise previous year question papers to revise key concepts, practice important questions, and understand the exam pattern used in past papers. BRpaper helps you find old question papers and semester-wise paper collection for better preparation before exams. It is not the official website of the university or board, so availability may vary by year and paper. These papers are useful for revision, identifying repeated topics, and getting familiar with theory question formats.

Solved Questions

Solved
  1. The soil which remains at place of its formation above parent rock is known as __________.
    Fill in the Blanks 1 Marks May-2010 • PSBTE DIPLOMA
  2. Void ratio of coarse grained is __________ than fine grained soils.
    Fill in the Blanks 1 Marks May-2010 • PSBTE DIPLOMA
  3. The soil particles finer than 2 micron size are known as __________.
    Fill in the Blanks 1 Marks May-2010 • PSBTE DIPLOMA
  4. The degree of plasticity of sand is __________.
    Fill in the Blanks 1 Marks May-2010 • PSBTE DIPLOMA
  5. Darcy’s law is valid for __________ type of flow.
    Fill in the Blanks 1 Marks May-2010 • PSBTE DIPLOMA
  6. The upward movement of soil is known as __________.
    Fill in the Blanks 1 Marks May-2010 • PSBTE DIPLOMA
  7. The property of holding soil particles together is called __________.
    Fill in the Blanks 1 Marks May-2010 • PSBTE DIPLOMA
  8. The moisture content corresponding to maximum dry density is termed as __________.
    Fill in the Blanks 1 Marks May-2010 • PSBTE DIPLOMA
  9. The maximum load intensity, which a soil can take without shear failure is termed as __________.
    Fill in the Blanks 1 Marks May-2010 • PSBTE DIPLOMA
  10. General exploration is called __________.
    Fill in the Blanks 1 Marks May-2010 • PSBTE DIPLOMA
  11. For dry soil, the degree of saturation is 100%.
    True / False 1 Marks May-2010 • PSBTE DIPLOMA
  12. Shear strength of soil depends upon its effective stress.
    True / False 1 Marks May-2010 • PSBTE DIPLOMA
  13. A well graded soil contains particle of one size.
    True / False 1 Marks May-2010 • PSBTE DIPLOMA
  14. Clay is highly compressible soil.
    True / False 1 Marks May-2010 • PSBTE DIPLOMA
  15. The cohesion less soils have less safe bearing capacities than cohesive soils.
    True / False 1 Marks May-2010 • PSBTE DIPLOMA
  16. Define void ratio of soil?
    Short Answer 3 Marks May-2010 • PSBTE DIPLOMA
  17. Define Coulomb’s law for C-φ soils?
    Short Answer 3 Marks May-2010 • PSBTE DIPLOMA
  18. State the choice of compacting equipments for different types of soils?
    Short Answer 3 Marks May-2010 • PSBTE DIPLOMA
  19. Define shear strength? Give its importance.
    Short Answer 3 Marks May-2010 • PSBTE DIPLOMA
  20. Compare fine and coarse soil?
    Short Answer 3 Marks May-2010 • PSBTE DIPLOMA
  21. Define allowable bearing capacity?
    Short Answer 3 Marks May-2010 • PSBTE DIPLOMA
  22. Explain limitations of Darcy’s law?
    Short Answer 3 Marks May-2010 • PSBTE DIPLOMA
  23. Define soil exploration? Give its purpose.
    Short Answer 3 Marks May-2010 • PSBTE DIPLOMA
  24. What is the importance of effective stress in engineering problems?
    Short Answer 3 Marks May-2010 • PSBTE DIPLOMA
  25. Give the concept of shallow and deep foundation?
    Short Answer 3 Marks May-2010 • PSBTE DIPLOMA
  26. Differentiate between compaction and consolidation?
    Short Answer 3 Marks May-2010 • PSBTE DIPLOMA
  27. Give the different causes of settlement?
    Short Answer 3 Marks May-2010 • PSBTE DIPLOMA
  28. A fully saturated sample of soil has a volume of 25 cm³ and weight of 40 gm. After drying in the oven, its weight is 28 gm. With the help of phase diagram, calculate (i) void ratio, e, (ii) porosity, n, (iii) water content, w, (iv) degree of saturation, S.
    Comprehension 10 Marks May-2010 • PSBTE DIPLOMA
  29. Define permeability? Give its importance. Explain the factors affecting permeability.
    Long Answer 10 Marks May-2010 • PSBTE DIPLOMA
  30. What are the soil properties governing the choice of foundation type. Give the methods of improving bearing capacity of soil.
    Long Answer 10 Marks May-2010 • PSBTE DIPLOMA
  31. Define well foundation? Explain its necessity. Draw the neat sketch showing important elements of well foundation.
    Long Answer 10 Marks May-2010 • PSBTE DIPLOMA

Explore all data

FAQ

Frequently Asked Questions

Answers about this subject, solved papers, and preparation.

Updated regularly
01 Where can I find Soil and Foundation Engineering previous year question papers?

You can use this page to look for subject-wise previous year question papers for Soil and Foundation Engineering in the 4th semester Diploma Civil Engineering course.

02 Are these papers available for Punjab State Board of Technical Education Diploma Civil students?

Yes, this subject page is made for the Punjab State Board of Technical Education Diploma in Engineering Civil stream, 4th semester.

03 Can I download Soil and Foundation Engineering question papers in PDF format?

This page is meant to help students find question papers and related exam material, including PDF-style paper resources where available.

04 How do these previous year papers help in exam preparation?

They help you revise faster, understand the paper pattern, and identify topics that appear more often in past exams.

05 Do you provide solved question papers or official answers?

BRpaper is focused on previous year and old question papers for practice. It does not claim to provide official answers or solved papers unless clearly shown on the page.