Solved question paper for MP Dec-2011 (DIPLOMA 4th)

Solved Question Paper

Microprocessors Dec-2011

PSBTE • DIPLOMA • Information Technology • 4th • Dec-2011

Microprocessors for Punjab State Board of Technical Education Diploma in Engineering Information Technology 4th semester is a subject page where students can quickly find subject-wise previous year question papers and exam-preparation material. It helps with revision, understanding recurring question styles, and getting familiar with the exam pattern and marking approach used in past papers. Use this page to check whether Microprocessors PYQ material is available before opening the subject page, and to support focused study for semester exams. BRpaper is not the official website of Punjab State Board of Technical Education or any university or board.

Solved Questions

Solved
  1. RAM stands for ________.
    Fill in the Blanks 1 Marks Dec-2011 • PSBTE DIPLOMA
  2. The most important register in the arithmetic unit is the ________.
    Fill in the Blanks 1 Marks Dec-2011 • PSBTE DIPLOMA
  3. When any interrupt is recognized, the 8085 automatically ________ the interrupt system.
    Fill in the Blanks 1 Marks Dec-2011 • PSBTE DIPLOMA
  4. The SIM instruction allow us to ________ the interrupt mask.
    Fill in the Blanks 1 Marks Dec-2011 • PSBTE DIPLOMA
  5. The mnemonics used in writing a program is called ________ language.
    Fill in the Blanks 1 Marks Dec-2011 • PSBTE DIPLOMA
  6. ________ is used to hold the memory address of the next instruction to be executed.
    Fill in the Blanks 1 Marks Dec-2011 • PSBTE DIPLOMA
  7. Each instruction contains two parts: operation code (opcode) and ________.
    Fill in the Blanks 1 Marks Dec-2011 • PSBTE DIPLOMA
  8. What is the addressing mode used in instruction LDA 0345 H?
    Short Answer 1 Marks Dec-2011 • PSBTE DIPLOMA
  9. PPI stands for ________.
    Fill in the Blanks 1 Marks Dec-2011 • PSBTE DIPLOMA
  10. The 8253 contains three independent 16-bit ________.
    Fill in the Blanks 1 Marks Dec-2011 • PSBTE DIPLOMA
  11. The normal operation of a microprocessor can also be interrupted by abnormal conditions or special instructions. Such an interrupt is called ________ interrupt.
    Fill in the Blanks 1 Marks Dec-2011 • PSBTE DIPLOMA
  12. Which of the following interrupt is unmaskable interrupt?
    Short Answer 1 Marks Dec-2011 • PSBTE DIPLOMA
  13. How many lines are there in data bus?
    Short Answer 1 Marks Dec-2011 • PSBTE DIPLOMA
  14. How many I/O ports can be accessed by memory mapped method?
    Short Answer 1 Marks Dec-2011 • PSBTE DIPLOMA
  15. What is the length of stack pointer?
    Short Answer 1 Marks Dec-2011 • PSBTE DIPLOMA
  16. Explain what is the function of ALU?
    Short Answer 5 Marks Dec-2011 • PSBTE DIPLOMA
  17. Explain the basic concept of memory mapping.
    Short Answer 5 Marks Dec-2011 • PSBTE DIPLOMA
  18. Explain the maskable and non maskable interrupt.
    Short Answer 5 Marks Dec-2011 • PSBTE DIPLOMA
  19. Explain the instruction cycle and machine cycle.
    Short Answer 5 Marks Dec-2011 • PSBTE DIPLOMA
  20. Explain what is 8251?
    Short Answer 5 Marks Dec-2011 • PSBTE DIPLOMA
  21. Explain the function of parity flag and carry flag in 8051.
    Short Answer 5 Marks Dec-2011 • PSBTE DIPLOMA
  22. Explain the register indirect addressing mode with suitable example.
    Short Answer 5 Marks Dec-2011 • PSBTE DIPLOMA
  23. What is the difference between RLC and RAR instruction?
    Short Answer 5 Marks Dec-2011 • PSBTE DIPLOMA
  24. What are handshake signals?
    Short Answer 5 Marks Dec-2011 • PSBTE DIPLOMA
  25. Explain the programmable interval timer 8253.
    Long Answer 10 Marks Dec-2011 • PSBTE DIPLOMA
  26. Explain the function of INTA signal of 8085.
    Short Answer Dec-2011 • PSBTE DIPLOMA
  27. Explain the function of INTR signal of 8085.
    Short Answer Dec-2011 • PSBTE DIPLOMA
  28. Explain the function of HOLD signal of 8085.
    Short Answer Dec-2011 • PSBTE DIPLOMA
  29. Explain the function of HLDA signal of 8085.
    Short Answer Dec-2011 • PSBTE DIPLOMA
  30. Explain the function of READY signal of 8085.
    Short Answer Dec-2011 • PSBTE DIPLOMA
  31. What is DMA data transfer scheme?
    Short Answer 10 Marks Dec-2011 • PSBTE DIPLOMA
  32. Discuss the function of DMA data controller 8257.
    Long Answer 10 Marks Dec-2011 • PSBTE DIPLOMA
  33. What operation is performed when the instruction DAD rp is executed?
    Short Answer Dec-2011 • PSBTE DIPLOMA
  34. What operation is performed when the instruction DAA is executed?
    Short Answer Dec-2011 • PSBTE DIPLOMA
  35. What operation is performed when the instruction CMA is executed?
    Short Answer Dec-2011 • PSBTE DIPLOMA
  36. What operation is performed when the instruction CMPM is executed?
    Short Answer Dec-2011 • PSBTE DIPLOMA
  37. What operation is performed when the instruction CMP r is executed?
    Short Answer Dec-2011 • PSBTE DIPLOMA
  38. Write short notes on Memory Mapped I/o scheme.
    Long Answer Dec-2011 • PSBTE DIPLOMA
  39. Write short notes on Evolution of Microprocessor.
    Long Answer Dec-2011 • PSBTE DIPLOMA
  40. Name the different methods of earthing.
    Short Answer Dec-2011 • PSBTE DIPLOMA
  41. State the function of panels in a sub station.
    Short Answer Dec-2011 • PSBTE DIPLOMA
  42. Write down the purpose of a relay in an electrical system.
    Short Answer Dec-2011 • PSBTE DIPLOMA
  43. Write down the function of a transformer in a substation.
    Short Answer Dec-2011 • PSBTE DIPLOMA
  44. Draw the electrical symbol of a push button in normally open position.
    Short Answer Dec-2011 • PSBTE DIPLOMA
  45. Draw the electrical symbol of a push button in normally closed position.
    Short Answer Dec-2011 • PSBTE DIPLOMA
  46. What do you mean by remote control of a motor?
    Short Answer Dec-2011 • PSBTE DIPLOMA
  47. A 3 phase induction motor is required to be started and stopped direct on line with the help of two push buttons. The motor gets started when ‘start’ push button is pressed. The motor steps when ‘OFF’ push button is pressed. Draw the control circuit and wiring diagram of the motor. Provide over load and short circuit protection to the motor.
    Long Answer 10 Marks Dec-2011 • PSBTE DIPLOMA
  48. A 3 phase induction motor is to be reversed directly. Design and draw its schematic diagram for the control circuit and complete wiring diagram by providing separate push buttons for both the directions of rotation. Provide over load and short circuit protection to the motor.
    Long Answer 10 Marks Dec-2011 • PSBTE DIPLOMA
  49. Draw and explain the diagram for anyone method of earthing with suitable necessary dimensions and material used.
    Long Answer Dec-2011 • PSBTE DIPLOMA
  50. Design and draw the bakelite sheet for the concealed conduit wiring, which should contain six push switches and a fan regulator.
    Long Answer Dec-2011 • PSBTE DIPLOMA
  51. Draw a neat layout of a 66 kv/11kv substation. Show the essential equipment in the diagram.
    Long Answer Dec-2011 • PSBTE DIPLOMA
  52. Draw half sectional elevation assembly and full plan of the field pole core and shoe and shunt field coil. All dimensions given in figure are in millimeter.
    Long Answer 12 Marks Dec-2011 • PSBTE DIPLOMA
  53. Draw the cross section of a U shaped drain with its foundation.
    Long Answer Dec-2011 • PSBTE DIPLOMA
  54. Draw the cross section of a circular brick masonry sewer.
    Long Answer Dec-2011 • PSBTE DIPLOMA
  55. Draw the cross section of soak pit for 10 users.
    Long Answer Dec-2011 • PSBTE DIPLOMA
  56. Draw the cross section of an inspection chamber.
    Long Answer Dec-2011 • PSBTE DIPLOMA
  57. Draw the plan of bathroom showing positions of lavatory, bathtub, washbasin, taps and showers.
    Long Answer Dec-2011 • PSBTE DIPLOMA
  58. Draw the cross section of a septic tank for 10 users.
    Long Answer Dec-2011 • PSBTE DIPLOMA
  59. What is the addressing mode used in instruction LDA 0345 H ?
    Short Answer 1 Marks Dec-2011 • PSBTE DIPLOMA
  60. Explain the functions of the following signals of 8085: i. INTA ii. INTR iii. HOLD iv. HLDA v. READY
    Long Answer 10 Marks Dec-2011 • PSBTE DIPLOMA
  61. What is DMA data transfer scheme? Discuss the function of DMA data controller 8257.
    Long Answer 10 Marks Dec-2011 • PSBTE DIPLOMA
  62. Explain what operation is performed when the following instructions are executed: a. DAD rp b. DAA c. CMA d. CMPM e. CMP r
    Long Answer 10 Marks Dec-2011 • PSBTE DIPLOMA
  63. Write short notes on following: a. Memory Mapped I/O scheme b. Evolution of Microprocessor
    Long Answer 10 Marks Dec-2011 • PSBTE DIPLOMA
  64. Name the different methods of earthing
    Short Answer Dec-2011 • PSBTE DIPLOMA
  65. State the function of panels in a sub station
    Short Answer Dec-2011 • PSBTE DIPLOMA
  66. Draw the electrical symbol of a push button in normally open and normally closed position.
    Very Short Answer Dec-2011 • PSBTE DIPLOMA
  67. A 3 phase induction motor is required to be started and stopped direct on line with the help of two push buttons. The motor gets started when ‘start’ push button is pressed. The motor stops when ‘OFF’ push button is pressed. Draw the control circuit and wiring diagram of the motor. Provide over load and short circuit protection to the motor.
    Long Answer 10 Marks Dec-2011 • PSBTE DIPLOMA
  68. Design and draw the bakelite sheet for the concealed conduit wiring, which should contain six plush switches and a fan regulator.
    Long Answer 10 Marks Dec-2011 • PSBTE DIPLOMA
  69. Fig 1 shows the isometric view of a field pole core and shoe and isometric view in section of shunt field coil. Draw half sectional elevation assembly and full plan. All dimensions given in figure are in millimeter.
    Long Answer 12 Marks Dec-2011 • PSBTE DIPLOMA
  70. Draw the cross section a septic tank for 10 users.
    Long Answer Dec-2011 • PSBTE DIPLOMA

Explore all data

FAQ

Frequently Asked Questions

Answers about this subject, solved papers, and preparation.

Updated regularly
01 Where can I find Microprocessors previous year question papers for PSBTE Diploma IT 4th semester?

You can use this subject page to look for Microprocessors PYQ material for PSBTE Diploma IT 4th semester and check availability before opening the paper.

02 Does this page provide subject-wise question papers for Diploma Information Technology semester 4?

This page is meant for subject-wise discovery, so students can quickly find Microprocessors previous year question papers for the 4th semester IT course.

03 Can I use old Microprocessors papers for revision?

Yes. Old question papers help students revise important topics, understand repeated question styles, and get a better idea of the exam pattern.

04 Is a solved paper or answer key guaranteed here?

Not always. BRpaper focuses on helping students find question papers, and any solved paper or answer key depends on what is available for this subject page.

05 Can I download the Microprocessors question paper PDF?

If a PDF is available for this subject, you can view or download it from the subject page. Availability may vary by paper.