Top 20 Questions of ED (DIPLOMA Production and Industrial Engineering 1st-2nd)
Most Repeated Questions
Top 20 Questions of Engineering drawing
Previous year question paper with solutions for Top repeated questions of Engineering drawing
PSBTE • DIPLOMA • Production and Industrial Engineering • 1st-2nd
Browse Top 20 questions of ED (DIPLOMA Production and Industrial Engineering 1st-2nd) previous year question papers for Top repeated questions of Engineering drawing. This page helps ED students find semester-wise papers for revision, exam practice, and understanding previous exam patterns. These are the top twenty repeated questions identified from previous year papers for ED (DIPLOMA Production and Industrial Engineering 1st-2nd), helping students focus on the most frequently asked topics.
Top repeated questions
Top 20-
1.
Section lines are drawn at an angle of ……………..
Appeared 3 times
Appeared in: May 2018, May 2017, Dec 2017
-
2.
Figure 2 shows an isometric view of an object. Draw to a full size scale the following views in First angle projection method.\\r\\n\\r\\ni) Sectional Front view ii) Sectional side view iii) Top view\\r\\n\\r\\n\\r\\n\\r\\n
Appeared 3 times
Appeared in: May 2018, May 2017
-
3.
Figure 1 shows the pictorial view of an object. Using 1st angle orthographic projection, draw it’s following orthographic views :-\r\n\r\n(a) Front view- Looking from the direction of arrow\r\n\r\n(b) Top view\r\n\r\n(c) Left side view\r\n\r\n\r\n
Appeared 3 times
Appeared in: May 2017, Dec 2017
-
4.
In first angle projection top view is below ……………
Appeared 2 times
Appeared in: May 2018, May 2017
-
5.
What is the difference between third angle and first angle projection?
Appeared 2 times
Appeared in: May 2018, Dec 2017
Login to see the full list of questions for this subject.
Login to see all