Top 20 Questions of MED-1 (DIPLOMA Production and Industrial Engineering 3rd)
Most Repeated Questions
Top 20 Questions of Mechanical Engineering Drawing-I
Previous year question paper with solutions for Top repeated questions of Mechanical Engineering Drawing-I
PSBTE • DIPLOMA • Production and Industrial Engineering • 3rd
Browse Top 20 questions of MED-1 (DIPLOMA Production and Industrial Engineering 3rd) previous year question papers for Top repeated questions of Mechanical Engineering Drawing-I. This page helps MED-1 students find semester-wise papers for revision, exam practice, and understanding previous exam patterns. These are the top twenty repeated questions identified from previous year papers for MED-1 (DIPLOMA Production and Industrial Engineering 3rd), helping students focus on the most frequently asked topics.
Top repeated questions
Top 20-
1.
A basic shaft is one whose upper deviation is?
Appeared 1 times
Appeared in: May 2022
-
2.
Railway axle is fitted in the hub of the wheel by which fit?
Appeared 1 times
Appeared in: May 2022
-
3.
The negative difference between the size of the hole and shaft before its assembly is called?
Appeared 1 times
Appeared in: May 2022
-
4.
Which is used to couple those two shafts together whose axis are not in line with each other but intersecting at a point?
Appeared 1 times
Appeared in: May 2022
-
5.
In the transition fit, the maximum shaft diameter is always _____ the minimum hole diameter.
Appeared 1 times
Appeared in: May 2022
Login to see the full list of questions for this subject.
Login to see all