Previous Year Very Short Questions of ACS (B-TECH electronics and communication engineering 4th)

Analog communication systems

Previous year question paper with solutions for Analog communication systems

Our website provides solved previous year question paper for Analog communication systems . Doing preparation from the previous year question paper helps you to get good marks in exams. From our ACS question paper bank, students can download solved previous year question paper. The solutions to these previous year question paper are very easy to understand.

These Questions are downloaded from www.brpaper.com You can also download previous years question papers of 10th and 12th (PSEB & CBSE), B-Tech, Diploma, BBA, BCA, MBA, MCA, M-Tech, PGDCA, B-Com, BSc-IT, MSC-IT.

Print this page
  1. Justify Square law equation of AM.
  2. Why we apply pre-emphasis circuit in FM before transmission?
  3. Where we use Vestigial side band transmission technique and why?
  4. What is FM Capture effect?
  5. Briefly explain the PLL direct FM transmitter.
  6. What do you mean by double spotting?
  7. Write basic difference between low level and high level modulation.
  8. A single side band signal contains 1KW. How much power is contained in the side bands and how much in the carrier?
  9. Define noise and noise figure.
  10. What is signal to noise ratio? Why is it important in communication systems?
  11. Find the modulation index if a 10 V carrier is amplitude modulated by three different frequencies with amplitudes of 1V, 2V and 3V respectively.
  12. Give two advantages of SSB operation compared with full carrier amplitude modulation?
  13. An FM modulator has deviation sensitivity of 30 kHz/V and operates at a carrier frequency of 175 MHz. Find the output frequency for an instantaneous value of modulating signal equal to 150mV.
  14. What is pre emphasis and de emphasis?
  15. Is it possible to use class C amplifiers to amplify an AM signal? Explain your answer.
  16. Why do some superheterodyne receivers use an RF stage while others do not?
  17. List three types of analog pulse modulation. Which pulse modulation scheme is used as an intermediate step in creation of pulse code modulation?
  18. Compare AM and FM (3 points).
  19. What are high level and low level modulation systems?
  20. What does modulation actually do to message and carrier?
  21. What is Flicker?
  22. A 400w carrier is modulated to a depth of 75% .Calculate the total power in a modulated wave.
  23. What do you mean by sensitivity and selectivity?
  24. What is the purpose of squelch circuits?
  25. Which type of noise occurs in a pulse amplitude modulation?
  26. What frequency range of AM and FM. broadcast bands?
  27. Write disadvantages of SSB transmission.
  28. Explain Dynamic Range?
  29. Which type of filters used in pre-emphasis and de-emphasis?